Publicidad
Idiomas disponibles
Idiomas disponibles
9. INSTALLING THE COOKING COMPONENTS
Parts Required:
2
x
Cooking Grids (#3)
1
x
Upper Cooking Rack (#4)
Installation:
•
Place the Cooking Grids, side-by-side, on the grid ledges inside the
Main Barrel. Place the Upper Cooking Rack on the upper ledge inside
the Main Barrel. The cooking rack will lock into place.
NOTE: To maintain the searing and grilling performance of your
Cooking Grids, regular care and maintenance is required.
10. PLACING THE GREASE BUCKET
Parts Required:
1
x
Grease Bucket (#22)
Installation:
•
Place the grease bucket on the spout hook on the end of the Main
Barrel. Ensure it is level to avoid grease spills.
•
The unit is now completely assembled.
11. CONNECTING TO A POWER SOURCE
STANDARD OUTLET
•
This appliance requires 110-120 volt, 60 Hz, 250 W. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off before use. The
control uses a 110-120 volt, fast-blow fuse to protect the board from
the ignitor.
GFCI OUTLETS
•
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the ignitor draws 200-700 watts of electricity
which can be too much power for a GFCI outlet to handle. Each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
•
ON THE ROAD
Disconnect the ignitor from the main wiring harness. Use the manual
start-up procedure. A Pit Boss® unit can operate using a 12 volt,
100 watt inverter plugged into your automobile outlet. To use the
automatic ignitor, it is recommended to use a minimum of a 1000
watt inverter.
IMPORTANT: Disconnect unit from power source when not in use.
9
4
3
10
11
22
11
Publicidad
