Publicidad
Idiomas disponibles
Idiomas disponibles
How to Install Your Switch Cover/Light Kit Assembly
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
your light kit.
1.
Disassemble switch cover/light kit assembly from
switch housing removing four screws. Retain these
screws for Step 4. (Figure 1)
2.
Remove one of the three screws in the support
bracket of motor. Slightly loosen the remaining two
screws. Assemble the switch housing to the support
bracket using the two key slots in the switch housing.
Replace the third screw and securely tighten all three
screws. (Figure 2)
3.
Securely attach 3-pin connector and 2-pin connector
from motor assembly to wiring harness socket within
switch cover/light kit assembly. (Figure 3)
4.
Assemble the switch cover/light kit assembly
onto the switch housing using the previously removed
screws and securely tighten all screws. (Figure 4)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
5.
Secure the glass to switch cover/light kit assembly
by twisting in a clockwise direction. Twist the glass
gradually
until it snaps onto the switch cover/light kit
assembly. Do not over-tighten. (Figure 5)
Switch Housing
Switch Cover
/Light Kit
Assembly
Switch Housing
Switch Cover/Light Kit
Assembly
Switch Housing
Switch Cover
/Light Kit
Assembly
13
Figure 1
Figure 2
Motor
Assembly
Figure 3
Figure 4
Switch Cover/Light Kit
Assembly
Glass
Figure 5
Publicidad
