Publicidad
Idiomas disponibles
Idiomas disponibles
Symptom
"READING" keeps flashing on the display.
Noise is generated.
While playing a track, sound is sometimes
interrupted.
Tracks/folders are not played back in the
order you have intended.
"USB ERROR" = "REMOVE USB" =
"PWR OFF/ON" scrolls on the display.
"NO FILE" appears on the display.
"NOT SUPPORT" appears and track skips.
"CANNOT PLAY" flashes on the display. /
"NO USB" appears on the display. / The
unit cannot detect the USB device.
"PLEASE CNNT BT ADAPTER" scrolls on
the display.
"BT FRONT/ BT REAR" cannot be selected. Check the <SRC SELECT> = <BT AUDIO> setting. (page 29)
No Bluetooth device is detected.
Pairing cannot be made.
Echo or noise occurs.
Phone sound quality is poor.
The unit does not response when you
tried to copy the phonebook to the unit.
The sound is interrupted or skipped during
playback of a Bluetooth audio player.
The connected audio player cannot be
controlled.
Remedy/Cause
A longer readout time is required. Do not use too many hierarchical
levels and folders. / Turn off the power then on again. / Reattach the
USB device again.
Skip to another file.
The tracks have not been properly copied into the USB device. Copy
tracks again into the USB device, and try again.
The playback order is determined by the file name. Folders with
numbers on the initial of their names are sorted in numerical order.
However, folders with no numbers on the initial of their names are
sorted according to the file system of the USB device.
An over-current occurs. Turn off, then turn on the unit.
Check whether the selected folder, the connected USB device,
or the iPod/iPhone contains a playable file.
Check whether the track is a playable file format.
Check whether the connected USB device is compatible with this
unit. / Reattach the USB device again.
Connect the USB Bluetooth Adapter (KS-UBT1) to the unit before
you can perform any operation.
Search from the Bluetooth device again. / Reset the unit, then
search from the Bluetooth device again.
Make sure you have entered the same PIN code to both the unit
and target device. / Disconnect the Bluetooth device and try pairing
again.
Adjust the microphone unit's position.
Reduce the distance between the unit and the Bluetooth mobile
phone. / Move the car to a place where you can get a better signal
reception.
You may have tried to copy the same entries (as stored) to the unit.
Press DISP or BACK to exit.
Reduce the distance between the unit and the Bluetooth audio
player. / Disconnect the device connected for Bluetooth Phone. /
Turn off, then turn on the unit. / Connect the player again, when
the sound is not yet restored.
Check whether the connected audio player supports AVRCP
(Audio/Video Remote Control Profile). (Operations depend on the
connected audio player.) / Disconnect and connect the Bluetooth
player again.
Continued...
ENGLISH
31
Publicidad
