ims PRO PULSEMIG 320 C Manual De Instrucciones página 51

The cooling unit (AUTO / ON / OFF) and the PURGE function of the cooling unit:
- AUTO: activation during welding and deactivation of the cooling unit 10 minutes after the end of welding.
- ON: the cooling unit is permanently controlled.
- OFF: the group is disabled.
- PURGE : function dedicated to purging the cooling unit or filling beams, the protections are then inhibited.
Product Reset (Partial / Total) :
- Partial (default value of the welding cycle).
- Total (factory configuration).
CALIBRATION
This mode is dedicated to calibrating the speed of motorized reels. The purpose of the calibration is to compensate for variations in the
reel speed in order to adjust the displayed voltage measurement and to refine the energy calculation. The procedure once launched is
explained with an animation on the screen.
This mode is also dedicated to the calibration of welding accessories such as torch, cable + electrode holder and cable + ground clamp.
The purpose of the calibration is to compensate for variations in accessory lengths in order to adjust the displayed voltage measurement
and refine the energy calculation. The procedure once launched is explained with an animation on the screen.
Important: The cable calibration must be repeated each time the torch, harness or ground cable is changed to ensure optimal welding.
PORTABILITY
This feature allows you to save the welding configuration of the machine.
It also allows you to load a recovered configuration on another machine and inject it into another.
Import Config. : Importing a USB key or «USER» configurations and its JOBS.
Export Config. : export to a USB key of the current «USER» configuration and its JOBS in the USB directory
JOB import: import of JOBS present under the USB directory Portability of a USB key.
JOB export: export of JOBS to a USB key according to the processes, in the USB\Portability directory.
PULSEMIG 320 C EN
51