Publicidad
Idiomas disponibles
Idiomas disponibles
EN
9.3
REPLACE THE BLADE
22
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting screw (20) with a wrench or
socket.
7. Remove the blade (22) and the fan (21).
8. Put back the fan.
9. Position a new blade with the cutting edges toward the
ground. Make sure two posts on the fan go through the
holes in the blade.
10. Tighten the mounting screw.
21
20
WARNING
WARNING
English
9.4
VERTICAL STORAGE
23
1. Remove the grass catcher.
2. Pull and turn the handle knobs 90°.
3. Fold down the handle.
4. Turn the handle knobs 90° to lock the handle into
position.
5. Stand the machine on end and make sure that the brackets
touch the floor.
Storage Switch
The machine has a storage switch (23) that prevents its
startup in the storage position.
It is necessary to remove the safety key and the battery pack
to prevent accidental startup or unapproved use. The storage
switch does not replace this function.
10
TROUBLESHOOTING
Problem
The handle is not
in position.
12
Possible cause
Solution
The bolts are not
Adjust the height
engaged correctly.
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
Publicidad
