Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Call Powermate Customer Service at 1-800-
445-1805 for any assembly issues or con-
cerns. Please have model and serial number
available.
The following tools are required to install the
accessory kit.
• See
Table 3: Accessories
NOTE: The wheels are not intended for over-
the-road use.
.
9
13
Add Engine Oil
Engine damage. Verify proper type and quantity of
engine oil prior to starting engine. Failure to do so
could result in engine damage.
1. Place generator on a level surface.
2. Verify oil fill area is clean.
3. Remove oil fill cap and wipe dipstick clean.
See
Figure
2-6.
Owner's Manual for Portable Generator
WARNING
(000100a)
(Tool Kit)
2
11
4
8
Figure 2-5. Wheel, Handle and Foot Assembly
CAUTION
See
Figure
Install wheels as follows:
1. Slide axle pin (3) through wheel (1), M12 x
4mm flat washer (6), and frame.
2. Install M12 x 4mm flat washer (6) and
insert cotter pin (12) through axle (3).
Bend tabs (of cotter pins) outward to lock
into place.
Install frame foot assembly as follows:
1. Slide M8 flat washer (8), rubber foot (5),
foot spacer (4) onto M8 x 80 bolt (10).
2. Align through holes in frame rail and
secure with M8 nyloc nut (11).
Install handle as follows:
1. Slide M8 x 50 bolt (9) through handle
bracket and handle (2). Secure with M8
nyloc nut (11).
11
5
10
(000135)
2-5.
6
7
12
Figure 2-6. Remove Dipstick
3
1
001592
000115
7
Publicidad
