Publicidad
Idiomas disponibles
Idiomas disponibles
(4) Auto slow mode
Stops for a preset time and/or changes the speed automatically to a preset speed.
Push the pushing button to the reverse ("L") position, then press the Auto stop mode selector switch to select the
setting.
Pushing button
Auto slow mode setting
Indicator lamps
Trigger
displacement:
Maximum
Auto slow
operation
Trigger
displacement:
Halfway
Uses
This function helps prevent nuts from dropping when loosening them.
NOTE
○ Depending on factors such as the bolt or nut size, socket used, and extent of tightening, there is a risk of nuts
accidentally dropping if the nut becomes detached from the screw thread while the power tool is operating.
○ The appropriate mode diff ers depending on the bolt and the material being screwed. Tighten in a few test bolts and
adjust the mode setting accordingly.
○ The tightening mode selector switch can only be set after the battery has been installed in the wrench and the trigger
switch has been pulled once.
Reverse
Fig. 25
1
Pauses after bolt loosening is detected.
Restarts after stopping for 0.5 seconds, then rotates at 60–350 /min depending on
how far the trigger is pulled.
* Rotation does not stop after restarting.
Rotation speed is reduced as follows depending on how far the trigger is pulled
after starting.
* Rotation does not stop.
60–330 /min
60–500 /min
For work of loosening bolts or nuts.
Auto stop mode selector switch
Auto slow mode
2
3
60–660 /min
English
4
60–830 /min
19
Publicidad
