Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
● Never try to cut materials that are too large for
the capacity of the machine since this may cause
damage.
● Applying cutting oil (spindle oil, machine oil,
and so on) along the shearing line may decrease
wear of the punch and die.
Use care to prevent cutting oil adhering to the
housing since the surface may be damaged.
● Never touch the application tool immediately
after use. The metal is hot and can easily burn
your skin.
1. Cutting plates
As shown in Fig. 6, hold the plates being cut parallel
with the machine and apply a light force while cutting.
When pocket cutting, make a hole 29/32" (23 mm) in
diameter or larger, as shown in Fig. 7, and start cutting
with the tip of the die holder.
Switch
1-5/8"
(40 mm)
29/32"
(23 mm)
Fig. 6
Fig. 7
2. Cutting corrugated and trapezoidal plates
(1) The cutting direction of this machine can be rotated
in 90° increments in 3 directions (A, B and C) (see
Fig. 8) by loosening the M8 hexagon socket set screw
mounting the die holder. Set the cutting direction in
the B or C direction to cut trapezoidal plates. After
that, securely tighten the M8 hexagon socket set
screw.
Machine
Screw M3
Cutting
Direction
Depression
Hexagon Socket
Hd. Set Screw M8
(2) Grip the machine fi rmly with both hands as shown in
Fig. 9, align with the shape of the trapezoidal plate,
push the machine forward until the die holder is at
right angles as shown in Fig. 9 and make the cut.
HOW TO REPLACE THE PUNCH AND DIE
CAUTION
Be sure to switch power OFF and disconnect the
battery from the body when changing application
tools.
1. Service life of the punch and die
Wear and damage to the cutting edges of the punch
and die can greatly infl uence the cutting operation.
Under normal usage, the service life of the punch and
die is as shown in the table below. Replace the punch
and die promptly when the end of the service life
approaches. The punch and die should be replaced
at the same time.
English
Fig. 8
Die Holder
Cutting Material
Fig. 9
13
Publicidad
