Seca 959 Manual De Instrucciones Y Garantía página 71

Transmit measured
results to a radio
receiver
Calculate and print out
BMI automatically
Automatic switchover
of weighing range
If the scale is integrated into a
less network, it can send the measurement results to
receive-ready instruments (wireless printers, PC with
USB wireless adapter) with the touch of a button.
Press the Enter key (send/print).
– Press key briefly: Send measured results to
all receive-ready equipment
– Hold down: Print out measured result using
wireless printer
If you use these scales with a wireless printer and a
length measuring device from the
system, you can calculate and print out the BMI auto-
matically.
NOTE:
The prerequisite for this function is that the
equipment devices are logged into a wireless
group (see "seca 360° wireless Network" on
page 77).
1. Carry out weighing.
2. Briefly press the Enter key (send/print) on the
scales.
The measured value is sent to the wireless printer
but not printed out.
3. Measure the height.
4. Hold down the Enter key (send/print) on the length
measuring device.
The measured value is sent to the wireless printer.
The BMI is calculated.
The height, weight and BMI will be printed out.
The scales are equipped with two weighing ranges. In
weighing range 1 (
weight display is available if capacity is reduced. In
weighing range 2 (
of the scale with adapted division of the weight display.
In weighing range 3 (
capacity of the scale.
After switching the scale on, weighing range 1 is active.
If a particular weight is exceeded, the scale switches
automatically to the appropriate weighing range.
seca 360° wireless
seca 360° wireless
), a more precise division of the
), you can use a greater capacity
) you can use the maximum
3
Operation • 71
English
wire-