Publicidad
Idiomas disponibles
Idiomas disponibles
Activate automatic
transmission (ASend)
Select print
option (APrt)
14. Press one of the arrow keys to see which devices
have been detected (here: Mo 3 for a wireless
printer).
Once you have integrated several devices in the
wireless group, press the arrow keys several times
to check that all equipment has been detected by
the scales.
15. Press the Enter key to leave the menu or wait until
you leave the menu automatically.
You can configure the scale so that the measurement
results are automatically sent to all receive-ready recip-
ients signed into the same wireless group (e.g.: wire-
less printer, PC with USB wireless module).
NOTE:
If you are using a wireless printer, ensure that
"off" is not set as a print option (see "Select
print option (APrt)" on page 81).
1. Switch the device on.
2. Select the menu item "ASend" in the "rf" submenu
and confirm your selection.
3. Select "on" and confirm your selection.
You will leave the menu automatically.
You can configure the device so that measured results
are automatically printed out by a wireless printer
logged into the wireless group.
NOTE:
This function is only available if the "learn" func-
tion has been used to integrate a seca wireless
printer in the wireless group.
1. Switch the device on.
2. Select the menu item "APrt" in the "rf" submenu
and confirm your selection.
3. Make the appropriate selection for your
combination of devices:
– HI: Measured results from length measuring
devices
seca 360° wireless Network • 81
English
Publicidad
