Publicidad
Idiomas disponibles
Idiomas disponibles
Combining several Vario devices: The connecting strip
VA 420 000/010 is required for the combination of
several Vario appliances. This is available separately as a
special accessory. Consider additional space
requirement for the connecting strip between the
appliances when making the cut-out (see installation
instructions VA 420 000/010).
Appliances can also be installed in individual cut-outs,
bearing in mind a minimum distance between the devices
of 2" (51 mm).
Drilled Hole for Control Knob
Possible types of installation:
Installation in the front of the base cabinet
▯
Installation in the countertop next to the appliance
▯
Installation in the countertop in front of the appliance
▯
Note: Follow the installation instructions provided for the
control knobs.
Installation Procedure
M ounting Control Knobs
I n s t a l l a t i o n P r o c e d u r e
Note: Follow the installation instructions provided for the
control knobs.
1.
Depending on the distance between the control
knobs, it may be necessary to break off the retaining
plate at the perforation. Hold the retaining plate in
place against the back of the control panel or the
bottom of the countertop, or secure it with the
enclosed screws.
2.
When installing a single control knob or when the
retaining plate has been broken at the perforation, use
2 screws to hold each individual retaining plate in
place to prevent it from rotating (C).
For stone countertops, use temperature-resistant two-
component adhesive (for metal to stone) to adhere the
retaining plate.
3.
Remove the protective film on the back of the
illuminated ring (A).
4.
Insert the control knob into the drilled hole (B) and
screw the nut on the back with the enclosed
installation aid (D).
5.
Connect all of the control knobs with the enclosed
shorter cables. The plugs must snap into the
sockets (E).
Note: The two cable connectors on the control knob
are identical.
Installation Procedure
en-us
11
Publicidad
