Garland CHOPPER 555 VE Manual De Instrucciones página 38

English
Unfold the work table, make sure they are at the same
level
Insert the hooks of the worktable into the supports
where you have previously loosened the wing nut
1
2
Tighten the wing nut again to secure the worktable.
5.2.3. MOUNTING THE CONTROL LEVERS
1
A
2
C
Remove pin (A) in order to remove locking bolt (B).
Insert the control lever making sure the end engages
with the slot in the connection bracket (C). Replace the
locking bolt (B) and the pin (A). Follow the same steps
to mount the other control lever.
5.2.4. ASSEMBLY OF THE CLAWS
1. Mount the retainers on the claws as shown in the
picture
2. Next, and in the same position shown in the figure,
connect the claws on the control levers with their
respective washers and wing nuts.
38/120
B
3