Garland CHOPPER 555 VE Manual De Instrucciones página 43

to ensure effective operation of the machine. For a
complete maintenance service, we recommend you to
take the lawnmower to your service technician.
7.2.2. CHANGING THE HYDRAULIC'S OIL
WARNING! You must not throw old oil
in a pipeline network or on the Earth.
The contamination of groundwater and
water tables is subject to heavy fines. There are
special collection places at service stations. If not,
any municipal authority will give you the relevant
information.
Change the hydraulic oil after every 150 hours of use.
Perform the following steps to change the oil:
1. Make sure that all moving parts of the machine are
stopped and that it is unplugged.
2. Place a container with a capacity to store the oil
used in the bandsaw (4 liters) next to the drain
screw.
3. Unscrew the screw (1) oil drain and wait until all of
the oil from the inside has been.
4. Push the blade until it reaches the bottom to
ensure that all the oil comes out.
5. Screw on the drain (1) screw.
6. Unscrew the filler cap (2) and refill with 4 liters of
new hydraulic oil.
7. Clean the oil screw rod and place it in the oil tank
to check the oil level.
8. Be sure that the oil has enough level so the rod is
spotted with oil between the two marks.
Max.
Oil level
Min.
Periodically check the oil level and make sure that it is
between the two marks on the dipstick. If it is below
the lowest you should oil-filled.
For a correct operation of your cachador with
hydraulic transmission system use a Garland oil for
hydraulic devices Ref. 7100000046 that can be found
at www.recaball.com
43/120
English
Filler cap (2)
Drain screw (1)