Dremel 8240 Instrucciones De Funcionamiento Y Seguridad página 20

1605A000BA 11-21 8240.qxp_8240 11/9/21 1:05 PM Page 20
EZ Lock™ Mandrel No. EZ402 has a spring loaded
sleeve and is used with cutting wheels, abrasive buffs
and polishing cloth.
the plug from the power source or the battery
pack from the tool before changing accessories.
Such preventative safety measures reduce the risk of
starting the power tool accidentally.
Always make sure accessory is properly seated on
mandrel before use. Incorrect seating of accessory
on mandrel may lead to personal injury or property
damage.
To load accessory:
1. Place EZ Lock™ mandrel into collet as deep as
possible and tighten collet nut.
Note: There is a blue spacer that will bottom out
on the collet nut, setting the mandrel to the
correct depth. When using with Dremel chuck,
back the mandrel out slightly before tightening.
2. Pull spring-loaded sleeve DOWN towards tool with
one hand and hold. You can brace the tool on the
body or work-bench for extra leverage (Fig. 1).
3. With the other hand, align bowtie shape on cut-off
wheel with mandrel and make sure metal insert is
facing away from the tool (Fig. 2).
4. Place wheel on the mandrel to a point just below
the bowtie on the mandrel and twist 90 degrees
until the bowtie shape on the wheel aligns with the
sleeve. Release sleeve. Wheel should lock in place
(Fig. 3).
5. When mounting sanding and polishing
accessories, align bowtie with metal insert on
bottom of accessory (Fig. 4 & 5).
To check for proper seating, hold shaft lock
button and twist accessory. Accessory will not be
able to rotate on mandrel.
To unload accessory:
1. Pull spring-loaded sleeve DOWN toward tool with
one hand (Fig. 1).
2. Hold sleeve down while twisting accessory 90
degrees.
3. Remove accessory.
Avoid damage to EZ lock™ mandrel by not letting it
contact the workpiece.
EZ Lock Operating Instructions
™
Always make sure the rotary
tool is "OFF" and disconnect
During use
FIG. 1
FIG. 2
FIG. 3
FIG. 4
FIG. 5
20