Publicidad
Idiomas disponibles
Idiomas disponibles
Fill Valve Replacement Procedure (continued)
NO TE: Do not overtighten. These are plastic parts. Never use pipe dope on any
water supply connection.
8)
pipe.
9) Turn water supply ON and check for leaks outside the tank.
NO TE:
Once the water stops filling the tank, some residual drops of water may drip
Depending on the manufacturing plant, you may have one of two of the following fill
valves:
For Type A Fill Valve:
Refer to the water level (WL) setting marked
on the inner wall of the tank. Allow the wa-
clockwise in the (+) direction to increase the
water level height (see Illustration 1). Turn
the adjustment screw counter-clockwise in
the (-) direction to decrease the water level
height. Flush the toilet to verify the correct
water level. Adjust as necessary.
For Type B Fill Valve:
There are no water level adjustments. The
fill valve has been preset at the factory.
MAINTENANCE INSTRUCTIONS
w
Water Level Adjustment
Type A
drops will subside.
Type B
Water Level
Ill. 1
6
.
e
Type C
Water
Level
Top of
Tube
Publicidad
