Descargar Imprimir esta página

GreenWorks Pro GPW 2003 Manual Del Propietário página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANDLE
• Align the pressure hose with the trigger handle and push up and into position.
• With hose pushed into position on the trigger handle, secure in place by turning the hose lock
clockwise until fully tightened.
NOTE: For easier installation of the hose to the unit or trigger, it is suggested to add pressure
washer or dish detergent to the rubber seal at each end of the hose. This will allow for easier
installation and a snug fit.
CONNECTING HIGH PRESSURE HOSE TO PRESSURE WASHER
• Connect one end of the hose to the water outlet connector and the other end to the trigger
gun.
Fig. 8
Outlet
Connector
High pressure
hose
15
See Figure 8.
See Figure 9.
L
Fig. 9

Publicidad

loading