3.
2.
15 mm
10
1.
6 mm
English
27437XX1 Installation
Rough-in: install a ½" NPT female fitting, recessed
⅜" behind the surface of the finished wall.
Position the shower arm against the wall over the
fitting.
Make sure that it is level.
Mark the positions of the screw holes.
Drill the screw holes using a mm bit (1).
Install the anchors (2).
Seal the wall around the anchors
using waterproof sealant (3).
Failure to seal the wall may lead
to water damage.
Wrap the threads on the nipple using Teflon tape.
Install the nipple.