Skil RT1322-00 Manual Del Propietário página 6

After completing a cut, turn the motor OFF and let it come to complete stop before
removing router from workpiece . Let the motor come to a complete stop before putting
the router down . Cutter bits coast after the power is turned off.
Only use router tables with on-board switch-controlled receptacles . Failure to use router
tables with all the appropriate safety features could result in serious personal injury.
Disconnect the tool from the power source before making any adjustments or changing
cutter bits.
If you are changing a bit immediately after use, be careful not to touch the collet/nut
or cutter bit with your hands or fingers. The heat buildup from cutting could cause severe
burns. Always use the wrench provided.
Avoid "climb cutting;" see "Feeding the Router" section in this manual . "Climb cutting"
increases the chance for loss of control resulting in possible serious injury.
Only use router bits suitable for the no-load speed of the tool .
Never use router bits with a diameter exceeding the maximum diameter specified in the
technical data section .
WARNING
WARNING
WARNING
could shock the operator and cause serious injury. Make sure that hidden electrical wiring,
water pipes, or other hazards are not in the cutting path.
6
Bits, sockets, and tools get hot during operation. Wear gloves when
touching them.
Wear ear protection. Exposure to noise can cause hearing loss.
To avoid injury, hold the tool by the insulated gripping surfaces only. If the
tool contacts hidden wiring or its own cord, exposed metal parts of the tool