Bluetooth; Bluetooth Connection - Pioneer MVH-390BT Manual De Instrucciones

Useful functions for iPod
Link play mode
You can access songs based on the artist, album, or genre currently playing.
1
While listening to a song, press and hold
2
Turn the M.C. dial to select the mode ([ARTIST], [ALBUM], [GENRE]), then
press to confirm.
The selected song/album will be played after the currently playing song.
NOTE
The selected song/album may be canceled if you use functions other than those from the
link play mode (e.g. fast forward and reverse).
iPod control
You can control the unit via a connected iPod.
The following iPod models are not compatible with this function.
– iPod nano 1st generation, iPod with video
1
Press BAND/ during playback, then select the control mode.
[CONTROL iPod]: The unit's iPod function can be operated from the
connected iPod.
[CONTROL AUDIO]: The unit's iPod function can only be operated by the
buttons on the unit or supplied remote control. In this mode, the connected
iPod cannot be turned on or off.
NOTES
• Switching the control mode to [CONTROL iPod] pauses song playback. Use the connected
iPod to resume playback.
• The following operations are still accessible from the unit, even if the control mode is set
to [CONTROL iPod].
– Pause, fast forward/reverse, song/chapter selection
• The volume can only be adjusted from the unit.
to enter the link play mode.
If five or more Bluetooth devices (e.g. a phone and separate audio player) are connected,
they may not work properly.
1
2
3
4
5
6
7
NOTES
• [DEVICE FULL] appears if the unit has already been paired with five other devices. In this
• Depending on the device, the PIN code is required in step 7. In this case, input [0000].

Bluetooth

Bluetooth connection

Important
Turn on the Bluetooth function of the device.
If you make a Bluetooth connection from the device, proceed to step 6.
Press to display the phone menu.
Turn the M.C. dial to select [BT SETTING], then press to confirm.
Turn the M.C. dial to select [ADD DEVICE], then press to confirm.
The unit starts to search for available devices, then displays them in the
device list.
• To cancel searching, press the M.C. dial.
• If the desired device is not in the list, select [RE-SEARCH].
• If there is no device available, [NOT FOUND] appears in the display.
Turn the M.C. dial to select a device from the device list, then press to
confirm.
Press and hold the M.C. dial to switch the displayed device information
between the Bluetooth device address and device name.
If you make a Bluetooth connection from the unit, proceed to step 7.
Select [Pioneer BT Unit] shown in the device display.
Make sure the same 6-digit number appears on this unit and the device,
then select "Yes" on the device.
case, delete one of the paired devices. See [DEL DEVICE] or [GUEST MODE] in the
Bluetooth settings (page 10).
9
En