Initial Settings; Radio; Receiving Preset Stations - Pioneer MVH-390BT Manual De Instrucciones

4
Turn the M.C. dial to select [YES], then press to confirm.

INITIAL settings

1
Press and hold SRC/OFF until the unit turns off.
2
Press and hold SRC/OFF to display the main menu.
3
Turn the M.C. dial to select [INITIAL], then press to confirm.
4
Turn the M.C. dial to select an option, then press to confirm.
Menu Item Description
FM STEP Select the FM tuning step from 100 kHz or 50 kHz.
[100], [50]
SP-P/O MODE Select when there is a full-range speaker connected to
the rear speaker output leads and there is a subwoofer
[REAR/SUB.W]
connected to the RCA output.
[SUB.W/SUB.W] Select when there is a passive subwoofer connected
directly to the rear speaker output leads and there is a
subwoofer connected to the RCA output.
[REAR/REAR] Select when there are full-range speakers connected to
the rear speaker output leads and RCA output. If there is
a full-range speaker connected to the rear speaker
output leads, and the RCA output is not used, you may
select either [REAR/SUB.W] or [REAR/REAR].
6
En
Menu Item Description
S/W UPDATE Select to confirm the latest system information on the
unit.
[SYSTEM INFO]
[SYSTEM Select to update the unit to the latest software and
UPDATE] initialize the unit settings. For details on the latest
software and updating, visit our website.
[BT VERSION] Select to display the system version of the unit and the
Bluetooth module.
[BT UPDATE] Select to update the unit to the latest Bluetooth
software. For details on Bluetooth software and
updating, visit our website.
SYSTEM RESET Select [YES] to initialize the unit settings. The unit will be
restarted automatically.
[YES], [NO]
(Some of the settings will be retained even after
resetting the unit, such as Bluetooth pairing information,
etc.)

Radio

The tuner frequencies on this unit are allocated for use in Western Europe,
Asia, the Middle East, Africa and Oceania. Use in other areas may result in poor
reception. The RDS (radio data system) function only works in areas that
broadcast RDS signals for FM stations.

Receiving preset stations

1
Press SRC/OFF to select [RADIO].
2
Press BAND/ to select the band from [FM1], [FM2], [FM3], [MW] or
[LW].
3
Press a number button (1/ to 6/ ).