Tectro CS 825 Instrucciones De Uso página 46

OPERATING INSTRUCTIONS
FEEL mode operating mode
The operating mode is selected automatically (HEATING, DRY,
FAN, COOLING) depending on the room temperature at the
time of selection.
With the remote control pointed towards the air conditioner.
1. Turn on
Press the ON/OFF/RUN button. When the device receives
a signal, the indication light RUNNING of the indoor unit
lights up.
If the unit is not in the FEEL mode.
2 Select FEEL mode
Press the MODE button
Switching from MODE to FEEL
Operating mode and temperature will be set according the indoor temperature.
Indoor temperature
Less than 20 °C
20 - 26°C
More than 26 °C
3. Set temperature
Press the g button or the h button.
By pressing the g button, the set value of the set temperature will be increased by 1°C.
After the temperature is increased by 2°C, the indication light will remain unchanged.
By pressing the h button, the set value of the set temperature will be decreased by 1°C.
4
46
Signal
receiver
Operating mode
Heating for
'heat pump' type
Fan for 'cooling only' type
DRY
COOLING
Desired temperature
23°C
18°C
23°C