Tectro CS 825 Instrucciones De Uso página 47

After the temperature is decreased by 2°C, the indication light will remain unchanged.
Note:
It might occur that there is no air flow with the unit in service.
When changing the mode the unit isn't always in service right away.
Cooling mode (COOL), heating (HEAT), and ventilate (FAN)
With the remote control pointed towards the air conditioner.
1. Press the power button. When the device receives a signal, the indication light "running" of the
indoor unit lights up.
2. Press the MODE button to select the desired mode, cooling, ventilating or heating.
In the heating and cooling mode it is possible to set the desired temperature with the g and h
3.
buttons and the desired fan speed, AUTO, LOW, MID of HIGH, with the FAN button on the remote
control.
4. In the mode ventilate it is not possible to set the room temperature. The speed of the fan can be set
with the FAN button to LOW, MID or HIGH.
If the fan is set to AUTO, the fan will automatically activate the most favourable fan speed. When the room
temperature comes closer to the set temperature, the speed of the fan will decrease.
Features of the HEATING mode
To heat
After the HEATING function is activated, the indoor unit will start blowing air after 2 – 5 minutes.
After heating
After the Heating function is stopped, the fan of the indoor unit will continue running for 2 – 5 minutes.
Defrost
During HEATING the device will defrost automatically for the best performance. This procedure normally
takes 2 - 10 minutes. The fan will stop during defrosting. After defrosting the HEATING function will restart
automatically.
Dehumidify mode
With the remote control pointed towards the air conditioner.
1. Press the power button. When the device receives a signal, the indication light "running" of the indoor
unit lights up.
2. Press the mode button and select the DRY mode. The air conditioner will now dehumidify the room.
3. When the room temperature reaches 18°C, the air conditioner will automatically stop dehumidifying.
The air conditioner will restart automatically when the room temperature reaches 20 °C.
When activating dehumidifying, the fan speed will be automatically set to AUTO.
The desired room temperature can not be changed in de dry mode. This is automatically set to 18°C
TIMER mode
When you set the timer with the TIMER button when you leave, it will be comfortable when you return
home. At night you can turn off the timer.
4
47