Installation - Yamaha ATS-1050 Manual De Instrucciones

Ocultar thumbs Ver también para ATS-1050:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

The orientation of the sound bar and the appropriate
remote control sensor depend on the installation
location.
Installing the sound bar on a TV cabinet,
etc.
1 Slide the installation position selector switch on
the bottom panel of the sound bar to the T (for
Tabletop) side (T, by default).
The sound quality appropriate to the installation will
be set.
2 Place the sound bar on a TV cabinet, etc., so that
the keys are facing the wall.
Remote control sensor
Installation position
(front panel)
selector switch
(bottom panel)
Cautions
• Do not stack the sound bar and a BD player or other device
directly on each other. Doing so may cause a malfunction due to
vibrations.
• Do not hold the speaker portion (fabric parts) on the front and the
top of the sound bar.
• The sound bar contains non-magnetic shielding speakers. Do not
place magnetically sensitive items (hard disk drive, etc.) near the
sound bar.
• Depending on your installation environment, it may be better to
connect the sound bar and external devices (such as a TV)
before installing the sound bar.
• Do not place the sound bar within 50 mm (2") of the TV.
Attaching the sound bar to a wall
1 Slide the installation position selector switch on
the bottom panel of the sound bar to the W (for
Wall mount) side.
The sound quality appropriate to the installation will
be set.
2 Following "How to install on the wall" below, install
the sound bar so that the keys face upwards.
Keys
Remote control
sensor (top panel)
Installation position selector
switch (bottom panel)
Cautions
• When installing the sound bar on a wall, all installation work must
be performed by a qualified contractor or dealer. The customer
must never attempt to perform this installation work. Improper or
inadequate installation could cause the sound bar to fall,
resulting in personal injury.
• Do not attach the sound bar to a wall that is made of weak
materials such as plaster or veneered woods. Doing so may
cause the sound bar to fall.
• Make sure you use commercially available screws that can
support the weight of the installation (specified in Step 2 on the
right). Using clamps other than specified screws, such as short
screws, nails, and two-sided tape, may cause the sound bar to
fall.
How to install on the wall
1 Attach the mounting template on a wall and mark
for the screw holes.
Tapes or thumbtacks
Mounting template (supplied)
Screw
holes
2 Remove the mounting template from the wall,
then install commercially available screws (as
illustrated below) at the points marked on the
wall.
7 to 9 mm
4 mm (#8)
(1/4" to 3/8")
20 mm (3/4")
or more
10 to 12 mm (3/8" to 1/2")
3 Peel off the backing paper from the spacers and
attach the adhesive face to the sound bar as
illustrated below.
Spacer
4 Hang the sound bar on the screws.
Mounting holes
on bottom of
sound bar
Cautions
• Fix the cables in place where they will not become loose. If your
foot or hand accidentally gets caught on a loose cable, the sound
bar may fall.
• Check that the sound bar is fixed securely after the installation.
Yamaha will bear no responsibility for any accidents caused by
improper installations.
5

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido