Publicidad
Idiomas disponibles
Idiomas disponibles
USING ELECTRIC POWER
(a) Let the engine stabilize and warm up for a few minutes after starting
(b) Plug in and turn on the desired 120 Volt AC single phase, 60 Hz electrical loads.
NOTE:
Be sure to ground the generator if the connected electrical equipment is grounded.
When the circuit breaker or no-fuse breaker turns off during operation, the generator is
overloaded or the appliance is defective.
Stop the generator immediately, check the appliance and /or generator for overloading
or defect and repair as necessary.
DO NOT connect 3-phase loads to the generator.
DO NOT connect 50 Hz loads to the generator.
Connecting a generator to your electric utility company's power lines or to another power
source may be against the law. In addition this action, if done incorrectly, could damage
your generator and appliances and could cause serious injury or even death to you or a
utility worker who may be working on nearby power lines. If you plan to run a portable
electric generator during an outage, please notify your electric utility company
immediately and remember to plug your appliances directly into the generator. Do not
plug the generator into any electric outlet in your home. Doing so could create a
connection to the utility company power lines. You are responsible for ensuring that your
generator's electricity does not feed back into the electric utility power lines. If the
generator will be connected to a building electrical system, consult your local utility
company or a qualified electrician. Connections must isolate generator power from utility
power and must comply with all applicable laws and codes.
Page 14
Publicidad
