DRYER SAFETY
Do not reach into the dryer if the drum is
■
moving.
Do not open door while dryer is in
■
operation. It will stop.
When loading or re-loading the dryer, avoid
■
touching hot metal parts of the drum (burn
risk).
Remove all objects from pockets such as
■
lighters and matches.
Cleaning and user maintenance shall not
■
be made by children without supervision.
WARNING: The appliance must not be
■
supplied through an external switching
device, such as a timer, or connected to a
circuit that is regularly switched on and off
by a utility.
The dryer must not be installed behind a
■
lockable door, a sliding door, or a door with
a hinge on the opposite side to that of the
dryer in such a way that full opening of the
dryer door is restricted.
The appliance is intended, but not limited,
■
to be used in public areas.
Children of less than 3 years should be
■
kept away unless continuously supervised.
This appliance incorporates an earth
■
connection for functional purposes only.
IEC Load Capacity - 9.0 kg.
■
Exhaust air must not be discharged into
■
a flue which is used for exhausting fumes
from appliances burning gas or other fuels.
6
All manuals and user guides at all-guides.com
■
■
■
■
■
■
■
SAVE THESE INSTRUCTIONS
Emergency stop control: After installation,
access to mains plug (gas dryer) or mains
supply (electric dryer) via a double-pole
switch must be maintained at all times in
order to ensure immediate deactivation of
the dryer in case of emergency.
The interior of the dryer and dryer exhaust
vent should be cleaned periodically by
Whirlpool authorized service personnel.
See "Electrical Requirements" section for
earthing instructions.
Adequate ventilation has to be provided to
avoid the back-flow of gases into the room
from appliances burning fuels, including
open fires.
Oil-affected items can ignite
spontaneously, especially when exposed
to heat sources such as in a tumbler
dryer. The items become warm, causing
an oxidation reaction in the oil. Oxidation
creates heat. If the heat cannot escape,
the items can become hot enough to catch
fire. Piling, stacking or storing oil-affected
items can prevent heat from escaping and
so create a fire hazard.
See DIMENSIONS/CLEARANCES
section for minimum installation spacing
requirements.
This dryer is not fitted with a supply cord
and a plug. Means for disconnection
from the supply mains having a contact
separation in all poles that provide
full disconnection under over-voltage
category III conditions must be provided,
otherwise means for disconnection must
be incorporated in the fixed wiring in
accordance with the wiring rules.