Sony XR-4740RDS Manual De Instrucciones página 9

Tip
When the traffic announcement starts while you are
listening to another programme source, the unit
automatically switches to the announcement and goes back
to the original source when the announcement is over.
Notes
• "NO TP" flashes for five seconds if the received station
doesn't broadcast traffic announcements. Then, the unit
starts searching for a station that does broadcast traffic
announcements.
• When the "EON" indication appears with "TP" on the
display, the current station makes use of broadcast traffic
announcements of other stations in the same network.
To cancel the current traffic
announcement
Press (AF/TA) momentarily.
To cancel all traffic announcements, turn
off the function by pressing (AF/TA) until
"AF" disappears.
Presetting the volume of traffic
announcements
You can preset the volume level of the traffic
announcements beforehand, so you will not
miss the announcement. When a traffic
announcement starts, the volume will be
automatically adjusted to the preset level.
1
Select the desired volume level.
2
Press (3) while holding down (SEL).
"TA VOL" appears and the setting is
stored.
Receiving emergency
announcements
If an emergency announcement comes in while
you are listening to the radio, the programme
will be automatically switched to the
announcement. If you are listening to a source
other than the radio, the emergency
announcements will only be heard if you set
AF or TA to on. The unit will then
automatically switch to these announcements
no matter what you are listening to at the time.
All manuals and user guides at all-guides.com
Presetting the RDS
stations with AF and TA
data
When you preset the RDS stations, the unit
stores each station's data as well as its
frequency, so you don't have to turn on the AF
or TA function every time you tune in the
preset station. You can select different setting
(AF, TA, or both) for individual preset stations,
or the same setting for all preset stations.
Presetting the same setting for all
preset stations
1
2
3
Presetting different settings for
each preset station
1
2
3
Tip
If you want to change the preset AF and/or TA setting
after you tuned in the preset station, you can do so by
turning on/off the AF or TA function.
Select an FM band.
Press (AF/TA) repeatedly and select
either "AF", "TA" or "AF TA" (for both AF
and TA functions).
Note that turning the "AF TA" function off
stores RDS stations as well as non-RDS FM
stations.
Press (SENS/BTM) for two seconds.
Select an FM band, and tune in the
desired station.
Press (AF/TA) repeatedly and select
either "AF", "TA" or "AF TA" (for both AF
and TA functions).
Press the desired preset number button
for two seconds until "MEM" appears.
Repeat from step 1 for presetting other
stations.
EN
9