Publicidad
1
2
6
5
8
6
126
iii-1
iii-2
4
3
iii-3
7
iii-3a
Installation
iii Installation procedure
Unit:
Refer to the drawing in i section for correct wheel
balancer positioning. For the wheel balancer fi x-
ing we recommend the use of metal elements
with a diameter of 8 mm, quality 8.8 or higher.
Supports for Accessories:
• Unpack the 4 threaded accessory support pins and
the support plates.
• Refer to Figure iii-1. Fit the 4 threaded accessory
support studs and the plates.
Threaded shaft: (except for "P" machines)
• Clean the threaded shaft and the hole in the main
shaft.
• Refer to Figure iii-2. Position the threaded shaft.
• Use a pin for screwing.
Clamping devices:
• Put the clamping devices on the accessory support
pins and in the appropriate housings.
Wheel guard:
• Refer to Figure iii-3.
The wheel guard infl uences the following operating
modes:
—
The measuring run is started by closing the wheel guard.
—
The wheel is braked by lifting the wheel guard during a
measuring run (code C5).
Fig. iii-3
—
Slide the wheel guard (1) on the support shaft (2) and
rotate the tube of the wheel guard until the wheel guard
fastening holes match with the support shaft holes.
—
Insert the M10 fastening screw (3) from with washers (4)
from below and tighten fully home the hexagon nut (5)
and washers.
Figure iii-3a (only for machines with Sonar)
—
Connect the plug of the cable (6) with the connector of
the machine (7) which is projecting out of the opening of
the machine cabinet.
—
Place the plug cable loosely inside the machine through
the hole in the machine cabinet.
Warning:
Since the cable is moved during the wheel guard
opening and closing, it must be routed through
retainer (8, Fig. iii-3a) under the guard support.
Publicidad
