Publicidad
80
5-40
5-41
5-42
Operation
5.12
Special functions
In this chapter all functions that may be accessed by
the operator are described. A function is a "mode" that
is not required to balance a wheel properly.
5.12.1 User function
Use this function to store or recall rim data (whee l type,
diameter, width, Offset, fi ne mode, oz mode and mm
mode) in or from the memory. 4 sets of wheel data (the
so-called user data) can be stored.
At switch-on, the unit shows the wheel data of the
current user. At the machine restart and until the current
user is not modifi ed or substituted, the unit still shows
+
the initial user data, even if the wheel type and the rim
data can be changed.
• To activate, press the "*" and the weight keys
simultaneously for 3 seconds Figure 5-40.
The function starts with the SAVE option.
The data can be saved by the user displayed on
the right. Refer to Figure 5-40 to select how to
arrange them.
To download the data (no saving):
• Select Enter when user "- -" is displayed. Refer to
Figure 5-41.
To save data:
• Select + or – to scroll along User A, b, C or d.
• Select Enter to save to the selected user.
The function proceeds with the RECALL option.
The data can be recalled from memory by selecting
the appropriate user. The selected user will be the
new current user, e.g. User b.
No recall required (no change in user required):
• Select Enter when user "- -" is displayed.
To recall data:
• Select + o – to scroll along User A, b, C o d.
• Select Enter to recall the selected user.
The current available wheel data will be replaced
by the recalled data (e.g.: "b" Figure 5-42).
Publicidad
