Publicidad
12
iNSPIRE iP300
Thank you for choosing a Turbosound loudspeaker product for your application. If you would like further information about this or any other Turbosound product,
please visit our website at turbosound.com.
Unpacking the Loudspeaker
After unpacking the unit please check carefully for damage. If damage is found, please notify your supplier at once. You, the consignee, must instigate any claim.
Please retain all packaging in case of future re-shipment.
Controls
(2)
(3)
(4)
(7)
(1) ENCODER KNOB toggles between Graphic and Edit modes (when pressed) and changes parameter values (when rotated).
(2) LCD SCREEN displays the current DSP module and parameter settings.
(3) PROCESS button accesses the DSP signal processing menu.
(4) SETUP accesses the setup features menu.
(5) EXIT button saves changes and returns to the previous menu screen.
(6) ENTER button selects sub-menu or confi rms parameter changes.
(7) INPUT A/INPUT B combo jacks accept input signals using XLR, balanced ¼" TRS or unbalanced ¼" TS connectors.
(8) LINK A/LINK B XLR connectors provide un-processed copies of the INPUT A or INPUT B signals.
iP300 DSP Menu Structure
(1)
PROCESS
(6)
(5)
(8)
*iPhone is a trademark of Apple Inc. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks is under license.
iP Series Analogue Connection
Despite their sophistication, iP speakers offer straightforward analogue connectivity, and you can easily arrange the iP system to allow simple control of levels from
other devices, such as mixers. You can also daisy-chain multiple iP speakers using only the analogue connections, and then directly control the overall level from your
mixer's master fader.
For example, you have four iP speakers and a mixer with simple left-right stereo outputs. For typical operation, set the DSP volume and input gain settings on all
speakers to a flat "0 dB" setting. Connect the mixer's left and right stereo outputs to the first two speakers' analogue INPUT A connections (the left and right mixer
outputs will go to separate speakers). Then, run cables from the OUTPUT analogue connections to the remaining two speakers. In a similar way, subwoofers can also be
linked to the analogue OUTPUT.
Menu
Sub-Menu
Fullrange
Main Screen
EQ (Equalisation)
POSIT (Position)
BT (Bluetooth)
Quick Start Guide
Function
Displays level indicators and model name.
Displays the following Bluetooth* status information:
•
Bluetooth symbol indicates connection to audio and/or
remote control device (iPhone*, etc.).
•
" " indicates that the remote control APP connected.
•
" " indicates audio streaming is connected.
•
"M" or "S" indicates that the speaker is linked to another iP
speaker as MASTER (left channel, "M") or SLAVE annel, "S").
Rotate the encoder knob to adjust the output volume.
Press the encoder knob enter the last used sub-menu.
Press the Process and Setup buttons to access sub-menus.
Volume
Rotate the encoder to change the output volume.
Sets input mixer level EQ and reverb for analogue input A and B,
INPUT
as well as level for Bluetooth.
Allows adjustment of three band equaliser with controls for bass,
midrange and treble.
Selects from 4 preset equalisations, depending on function and
MODE
music type.
Selects DSP compensation depending on the speaker position:
stand, wall, corner.
SETUP
Sets LCD back panel contrast, device lock and factory reset.
Lets you pair the speaker with mobile Bluetooth devices and link to
another iP speaker as MASTER / SLAVE.
INFO
Displays model and firmware information.
Indicates device is updating firmware from APP software
DFU
via Bluetooth.
13
Publicidad
