Pit Boss MAHOGANY 1000 Serie Montaje Y Operación página 10

8. SECURING THE CHIMNEY
Parts Required:
1 x Chimney Gasket (#11)
1 x Chimney (#12)
2 x Screw (#A)
2 x Washer (#B)
2 x Locking Washer (#C)
Installation:
• Locate the chimney opening on the side of the Main Barrel. From the
outside, secure the Chimney Gasket and Chimney to the side panel
using two screws, locking washers, and washers. The screw will fasten
to the pre-mounted nut on the inside of the Main Barrel.
NOTE: Ensure the chimney cap allows for air to escape.
9. INSTALLING THE FRONT SHELF BRACKETS
Parts Required:
1 x Front Shelf Bracket / Left (#25)
1 x Front Shelf Bracket / Right (#26)
6 x Screw (#A)
6 x Washer (#B)
6 x Locking Washer (#C)
Installation:
• Attach one Front Shelf Bracket to the front of the Grill Barrel by using
three screws. Install each screw half-way, then tighten completely
when all three screws are mounted and aligned properly. Repeat the
same installation for the other Front Shelf Bracket.
10. MOUNTING THE FRONT SHELF
Parts Required:
1 x Front Shelf (#27)
2 x Screw (#D)
2 x Nut (#H)
Installation:
• From underneath, insert the screw (from the inside) into the Front
Shelf and the Front Shelf Bracket, then lock it with a nut. Repeat
installation for the other side of the Front Shelf.
NOTE: When installed correctly, the Front Shelf can be raised (for use) or
lowered (for storage) with ease.
IMPORTANT: Avoid using the shelves to move or lift the grill. The
weight of the unit will cause the shelves to break, which is not covered
by warranty.
the chimney opening on the side of
n barrel. From the
, secure the chimney and chimney
10
A C B
A C B
Locate the chimney opening on the side of
the main barrel. From the
outside, secure the chimney and chimney
gasket to the side panel
using two screws, locking washers, and
washers. The screw will fasten
to the pre-mounted nut on the inside of
the barrel.
Attach one front shelf bracke
front of the grill barrel by
screws. Install each screw ha
8
12
11
9
26
25
B
A C
AX2
BX2
CX2
10
H
D
27
B
C
A