Publicidad
Idiomas disponibles
Idiomas disponibles
Additional controls and important information.
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
When the air conditioner is turned on, it will
automatically start in the setting last used.
Power Outage Recovery Feature
In the case of a power outage or interruption, the
unit will automatically re-start in the settings last
used after the power is restored. The Timer and
Cool Mode
Use the Cool mode with High (3), Med (2) or
Low (1) fan for cooling. Use the Increase
Decrease
between 64°F and 86°F in 1°F increments.
A thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air
will become cooler. Set the thermostat at a higher
number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned
on while set to Cool, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
Fan Mode
Use the Fan at High (3), Med (2) or Low (1) to provide
air circulation and filtering without cooling.
Vent Control
The vent control is located on the inside of the air
louvers in the lower right corner.
When set at CLOSE , only the air inside the room
will be circulated and conditioned. When set at
OPEN , some inside air is exhausted outside.
Air Direction—Up and Down
Fingertip pressure on the horizontal louvers adjusts
the air direction up or down.
Air Direction—Side-to-Side
The side-to-side air direction is adjusted
by the louver levers or by grasping and moving
the inner vertical louvers.
pads to set the desired temperature
Sleep features will reset to the original setting.
You may need to set a new time if desired.
Cooling Descriptions
/
For Normal Cooling— Select the Cool mode
and High (3) or Med (2) fan with a middle set
temperature.
For Maximum Cooling— Select the Cool mode
and High (3) fan with a lower set temperature.
For Quieter & Nighttime Cooling— Select the
Cool mode and Low (1) fan with a middle set
temperature.
NOTE: If you switch from a Cool setting to Off or to
a fan setting, wait at least 3 minutes before switching
back to a Cool setting.
Since fan only settings do not provide cooling,
a temperature setting will not be displayed.
To open the vent, push the lever to the
right. To close it, push it to the left.
ge.com
5
Publicidad
