Publicidad
Idiomas disponibles
Idiomas disponibles
Window Installation Instructions
1
WINDOW REQUIREMENTS
• These instructions are for a standard
double-hung window. You will need to
modify them for other types of windows.
• All supporting parts must be secured
to firm wood, masonry or metal.
• The electrical outlet must be within
reach of the power cord.
30" to 40"
(With accordion panels)
STORM WINDOW REQUIREMENTS
2
A storm window frame will not allow the
air conditioner to tilt toward the outside,
and will keep it from draining properly.
To adjust for this, attach a piece of wood
to the sill.
WOOD PIECES –
WIDTH: 2"
LENGTH: Long enough to fit inside the
window frame.
THICKNESS: To determine the thickness,
place a piece of wood on the sill to make
it 1/2" higher than the top of the storm
window frame or the vinyl frame.
Attach securely with nails or screws
provided by the installer.
1/2" higher
than storm
window
frame
Storm window
frame
" min.
18
1
⁄
2
1/2" higher
than vinyl frame
(on some windows)
Wood
Sill
Vinyl frame
PREPARE THE WINDOW
3
Cut the window sash seal to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash.
REMOVE THE FRONT GRILLE
4
(IF ATTACHED)
A
Open the inlet grille
downward by pulling
out the upper corners
of the inlet grille.
Lift it up and off.
B
Grasp the filter
at the top center
and pull it out.
C
Remove the screw
from the grille.
D
Gently but firmly grasp
the lower grille corners,
press in on the case
sides and pull forward
to release.
NOTE: Do not pull the
bottom edge toward you
more than 3" or you
may damage the tabs of the grille.
E
Lift the grille up and off the top tabs.
9
Publicidad
