Ryobi RPW120B Traducción De Las Instrucciones Originales página 8

TROUBLESHOOTING
Problem Possible causes
Fluctuating Pump sucking air
pressure
Valves dirty, worn out or
stuck
Pump seals worn out
Product stops Thermal sensor activated Leave the cleaner for 15 minutes to cool down.
Nozzle partially blocked
Product Air in inlet hose/pump
pulsating
Inadequate
mains water
Nozzle partially blocked
Water fi lter blocked
Hose kinked
Product starts, Pump/hoses or accessory
but no water frozen
comes out
No water supply
Water fi lter blocked
Nozzle blocked
No detergent Nozzle adjusted to high
pressure
6 | English
Solution
Check that hoses and connections are air tight.
Bring the product to an authorised service
centre for service or repair.
Bring the product to an authorised service
centre for service or repair.
Clean the nozzle.
Allow the product to run with open trigger until
regular working pressure resumes.
supply of Check that the water supply corresponds to
the specifi cations required (see model tag).
Avoid using long, thin hoses.
Clean the nozzle.
Clean the fi lter.
Straighten out hose.
Wait for pump/hoses or accessory to thaw.
Connect the water inlet port to a water supply.
Clean the fi lter.
Clean the nozzle.
Adjust to low pressure.