Packing And Unpacking; Unpacking, Moving, Use And Storage; Setting To Work - Connection To The Power Supply - Nilfisk VHW320 Manual De Instrucciones

VHW320 - VHW321 - VHW420 - VHW421 - VHW440

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
VHW320 MODEL
L - M - H
ATEX Z22
ATEX Z2
IC
VHW321 MODEL
L - M
H
ATEX Z21
ATEX Z22
ATEX Z2
VHW420 MODEL
STD
ATEX Z22
IC
C
VHW421 MODEL
L - M
H
ATEX Z21
GB
ATEX Z22
VHW440 MODEL
STD
IC
C
C393
Figure 3
A B C
(mm) (mm) (mm)
500 900 1360
500 900 1360
500 900 1360
500 900 1630
A B C
(mm) (mm) (mm)
500 900 1360
500 900 1360
500 900 1360
500 900 1360
500 900 1360
A B C
(mm) (mm) (mm)
620 1050 1660
620 1050 1660
620 1050 1950
620 1050 1950
A B C
(mm) (mm) (mm)
620 1050 1660
620 1050 1660
620 1050 1660
620 1050 1660
A B C
(mm) (mm) (mm)
620 1050 1660
620 1050 1950
620 1050 1950

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight.
Setting to work - connection to the power
kg
supply
86
86
■ Make sure there is no evident sign of damage to
91
the vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
107
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
kg
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
91
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the power supply
96
cords must be protected against splashes of water.
99
■ Check for proper connection to the electrical
mains.
91
■ Use the vacuum cleaner only when the cord
96
that connects to the electricity mains is in good
condition (damaged cords could lead to electric
shock!).
■ Regularly check there are no signs of damage,
kg
excessive wear, cracks or aging on the electric
cord.
121
121
153
When the device is operating, do not:
■ Crush, pull, damage or tread on the cord that
162
connects to the electrical mains.
■ Only disconnect the cord from the electrical mains
by removing the plug (do not pull the cord).
kg
■ Only replace the electric power supply cord with
one of the same type as the original: FROR, the
136
same rule applies if an extension is used.
■ The cord must be replaced by the manufacturer's
139
Service Center staff or by equivalent qualified
personnel.
149
136
kg
134
165
175
6
WARNING!
WARNING!
03/2017