Philips Norelco 9000 Seriesl Manual Del Usuario página 25

_S9321.indd 27
When the SmartClean System is ready for use,
do not move appliance to prevent leakage.
◗ When the cleaning cartridge filter is full, the
replacement symbol blinks indicating the
cleaning cartridge should be replaced. See
'Replacing the SmartClean System Cartridge'.
Cleaning the Shaver in the
SmartClean System
C
◗ SmartClean System has two phases: a cleaning
phase and a drying phase.
◗ If the shaver does not contain enough power
for one (1) shave, the SmartClean System
may not work properly. Charge the shaver
in the SmartClean System before using the
SmartClean System to clean your shaver.
◗ If you use the shaver with shaving foam or gel,
quickly rinse under hot water before cleaning
in the SmartClean System.
Connect the small plug to the SmartClean
1
System. Connect the power plug into any
100V to 240V AC outlet. Use only the
power cord provided.
C
Press the top cap to open the SmartClean
2
System.
3 Place the SmartClean System on a flat,
level surface. Make sure the seal has been
ENGLISH
27
6/26/14 3:15 P