Publicidad
For dealers
When the projector is mounted on the ceiling, a
Sony bracket or recommended equivalent must
be used for installation.
Be sure to secure the cabinet cover firmly when
installing to the ceiling firmly.
Do not use any parts other than the supplied
extension studs.
Tighten the extension studs on the unit with a
torque of 1.3 ± 0.1 N·m. Then, install the ceiling
bracket tightening the screws on the extension
studs with a torque of 1.1 ± 0.1 N·m.
Under the following conditions, do not use:
– the extension studs if there are extension studs
applied,
– with the extension studs loose,
– damaged extension studs.
After attaching the extension studs to the unit,
do not carry the unit by holding the extension
studs.
Safety precautions for installing the unit on
a ceiling
Never mount the projector on the ceiling or
move it by yourself. Be sure to consult the store
where you purchased the projector or a
dedicated installer.
When installing the unit on a ceiling, be sure to
use a safety wire, etc., to prevent the unit from
falling. For the installation, be sure to consult the
store where you purchased the projector or a
dedicated installer.
To use the projector safely, ask the store where
you purchased it or a dedicated installer for
periodic inspections.
On Installation
When installing the unit, leave space between
any walls, etc. and the unit as illustrated.
Top view
More than
50 cm
11
(19
/
")
16
30
GB
More than 50 cm
11
(19
/
")
16
More than
50 cm
11
(19
/
")
16
Avoid using if the unit is tilted more than 15
degrees horizontally.
Avoid using the unit in a location where the
temperature or humidity is very high, or
temperature is very low.
Avoid installing the unit in a location subject to
direct cool or warm air from an air-conditioner.
Installing in such a location may cause
malfunction of the unit due to moisture
condensation or rise in temperature.
Avoid installing the unit in a location near a heat
or smoke sensor. Installing in such a location
may cause malfunction of the sensor.
Avoid installing the unit in a very dusty or
extremely smoky environment. Otherwise, the
air filter will become obstructed, and this may
cause a malfunction of the unit or damage it.
When using the unit at an altitude of 1,500 m or
higher, set "High Altitude Mode" to "On" in the
Installation menu. Failing to set this mode when
using the unit at high altitudes could have
adverse effects, such as reducing the reliability
of certain components.
Publicidad
