Garland GEISER 491 FE Manual De Instrucciones página 24

English
aspirate water, stop the pump and check that there
is sufficient water in the aspiration point. If there is
enough water flow, disconnect the machine and check
the aspiration tube.
6.2.2. START UP (NOT FIRST START UP)
1. Open the circuit for aspiration and impulsion.
2. Place the security switch in position ¨I¨.
6.3. CHECKING POINTS AFTER START UP
Check that, after opening the circuit, when starting the
machine the noise is normal, that the machine does
not vibrate and that the pressure flow is adequate.
It is important to check that all parts are well
tightened. If you detect any anomaly, stop the machine
straight away and check the machine carefully. In
case of any water leakages, check the installation
carefully.Never carrying on working if the machine is
not working correctly and take to the nearest service
dealer if the machine does not function adequately.
6.4. PROTECTION AGAINST OVERCHARGING
This machine has a safety switch that will
disconnect the machine in case of overload due to
excessive work. If you detect that the machine does
not start, it may be because the safety switch has
been activated. In that case wait 15-20 minutes and
the machine will turn on again automatically.
7. MAINTENANCE AND SERVICE
The removal of the security elements, a
poor maintenance or the substitution of
spares and accessories by non original
ones can all cause severe corporal damages.
Always carry out all the maintenance
work with the machine unplugged from
the mains.
We recommend a visual control every 3 months to
check the general state of the machine; look for water
leakages, loose parts and check the conexions. This
way the machine will have a good working life. If you
find any anomaly, take the machine to your nearest
service dealer.
24/88