Publicidad
Idiomas disponibles
Idiomas disponibles
Overview
Different electric power tools are described
in these instructions.
The illustrated electric power tool may differ
in detail from the one which you purchased.
Please fold out the pages
at the end of these instruc-
tions.
Fig.
1
Spindle
2
Threaded flange
a Clamping nut
a Clamping flange
3
Guard hood
Can be adjusted without a tool through
360° by means of 12 notches.
4
SoftVib handle with holding wrench
Handle can be fitted to the left or right.
To change the grinding tool, unscrew
the cover.
5
Spindle lock
Secures the spindle when the tool
is changed.
6
Gear head
With air outlet and direction-of-rotation
arrow.
7
Switch rocker
Switches the power tool on and off.
With notched position for continuous
operation.
8
Rear handle
9
Dial for preselecting the speed
(L 3410 VR, LE 14–7 125, L 1506 VR
only)
10 4,0 m power cord with plug
11 Rating plate (not illustrated)
L 1506 VR only:
12 Grip hood with fastening screws
13 Handle
14 Face spanner
20
Instructions for use
WARNING!
Before carrying out any work on the angle
grinder, always pull out the mains plug.
Before switching on the power tool
Unpack the angle grinder and check that
there are no missing or damaged parts.
Attach the guard
WARNING!
When using the angle grinder for roughing
or cutting, never work without the guard.
Fig.
Pull out the mains plug.
Attach the guard. Lugs on the guard
hood must be located in the flange
recesses.
Turn guard hood clockwise.
Rotation is possible in one direction
only!
Remove in reverse order.
Attach the handle
Fig.
NOTE
It is not permitted to operate the electric
power tool without the handle.
Attach handle cover (L 1506 VR)
NOTE
It is not permitted to operate the electric
power tool without the handle/handle cover.
Remove the guard.
Loosen screws or handle.
Fig.
Push on handle cover (1.).
Tighten screws (2.).
Angle grinder
Publicidad
