Worx WX101.X Manual De Instrucciones página 10

How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
10
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for driving in and loosening
screws as well as for drilling in wood, metal and
plastic.
ASSEMBLY AND OPERATION
ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off trigger switch and
disconnect tool from power source when
changing accessories. Always ensure the bit is secure
before starting the tool. Damage to the Chuck or a
loose bit may cause possible personal injury.
-- Removing the bits
20V Cordless Drill Driver
-- Inserting the bits
OPERATION
Forward/reverse rotation control
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
TWO-SPEED GEAR CONTROL
WARNING: To prevent gear
damage, always allow the chuck
to come to a complete stop before
changing the direction of rotation.
TORQUE ADJUSTMENT
Drilling, Screw driving
Operating the On/Off switch
WARNING: Do not operate for
long periods at low speed
because excess heat will be produced
internally.
LED light indicator
Before operation, the LED light will be
activated when the On/Off switch is
slightly depressed.
WARNING: To turn on the light,
press the On/Off switch and
make sure the Forward/Reverse
Rotation Control is on right/left
position.
The tool and battery are equipped
with a protection system. When
the LED Light is quickly flashing 60
seconds and turn off, the system will
automatically cut off power to the tool
to extend battery life. The tool will
automatically stop during operation
if the tool and/or battery are placed
under one of the following conditions:
• Overloaded: The tool is operated
in a manner that causes it to draw
an abnormally high current. In this
FIGURE
situation, release the Trigger Switch
on the tool and stop the application
that caused the tool to become
See Fig. A1
overloaded. Then pull the Trigger
Switch again to restart.
See Fig. A2,
• Overheated: Under the condition
A3
above, if the tool does not start, the
See Fig. A4
Tool and Battery are overheated. In
this situation, let the Tool and Battery
cool before pulling the Trigger Switch
again.
• Low battery voltage: The
remaining Battery capacity is too low
and the tool will not operate. In this
situation, remove and recharge the
Battery.
See Fig. B1
See Fig. B2
See Fig. C1,
C2, C3
See Fig. D
See Fig E1,
E2
See Fig. F
See Fig. F
EN