Bosch BAT 690 Battery Manual Original página 17

4. Initial startup
4.1 Connecting charging cables to the
BAT 690
1. Plug the connection socket of the black charging
cable into the connector (–), turn clockwise and
tighten by hand.
2. Plug the connection socket of the red charging
cable into the connector (+), turn clockwise and
tighten by hand.
"
Charging cables connected to the BAT 690.
4510027-09_Ko
Fig. 2: Connecting charging cables to the BAT 690
4.2 Install the wall mounting
Depending on the mounting surface, select appropriate
bolts and anchors for fastening the wall mounting. The
type of fastening depends on the mounting surface
(e.g. concrete, hollow block, perforated metal plate,
wooden panel). Consult specialty retailer or particular
manufacturer for information. The overall weight of the
wall mounting with the BAT 690 attached can be as
much as approx. 9 kg. Therefore only use screws and
anchors that can withstand this load.
4510026-08_Ko
Fig. 3: BAT 690 with wall mounting
Robert Bosch GmbH
Initial startup | BAT 690 | 17 |
1. Sufficiently fasten the wall mounting depending,
taking the mounting surface into account.
2. Hook BAT 690 into wall mounting.
i
The four bases of the BAT 690 must always be
hooked into the wall mounting at the top and
bottom. The charging cables and power supply cable
can be hooked into the wall mounting (see fig. 3).
5. Operation
5.1 Essential information
Danger – Flammable gases released when
charging defective batteries!
Risk of serious injury or death due to gas
explosion.
¶
Avoid naked flames and spark formation.
1. Do not switch off the BAT 690 and do
not remove the charging clips.
2. Thoroughly ventilate the area immediately.
3. Switch off the BAT 690 after ventilating.
5.1.1 Installation location
¶
Place BAT 690 on a solid subsurface or hook onto
the fastened wall mounting.
¶
The installation location must have an adequate
loadbearing capacity. Pay attention to the weight
of the BAT 690 and the weight of the battery to be
charged.
¶
Note and maintain a safe distance of 0.5 m
between the BAT 690 and battery.
¶
Protect the BAT 690 against damp and moisture.
¶
Never cover up the BAT 690.
¶
On installing the BAT 690 maintain a lateral
clearance of at least 15 cm for ventilation.
5.1.2 Connecting and charging
¶
Voltage must be supplied to the BAT 690 via a
grounded mains voltage system.
¶
Only use of the charging cables supplied by Bosch.
¶
The power supply cable and charging cables must
be in perfect condition.
¶
Never extend or shorten charging cables.
¶
Only charge batteries in well ventilated areas.
¶
Avoid naked flames and spark formation when
charging batteries.
¶
Only connect intact batteries in parallel for
charging.
¶
Do not attempt to charge non-rechargeable
batteries.
¶
Do not charge lithium iron phosphate batteries
(LFP = LiFePO ) without the battery management
4
system (BMS).
en
|
1 689 989 234 2022-01-24