Publicidad
Idiomas disponibles
Idiomas disponibles
Gas connection for gas hob
The gas hob should be connected to the gas-supply by a registered installer. During
installation it is essential to fit an approved gas tap to isolate the supply from the hob
for the convenience of any subsequent removal or servicing. Connect the hob to the
gas mains or liquid gas, it must be carried out according to the prescribed regulation in
force, and only after it is ascertained that it is adaptable to the type of gas to be used. If
not, follow the instructions indicated in the paragraph headed "Adaptation to different
gas types". In the case of connection to liquid gas by tank, use pressure regulators that
conform to the regulation in force.
IMPORTANT: For safety, for the correct regulation of gas use and long life of the hob,
ensure that the gas pressure conforms to the indications given in table 1 "Burners and
Nozzle Specifications".
Connection to non-flexible tube (copper or steel)
• Connection to the gas source must be done in such a way as to not create any
stress points at any part of the gas hob.
• The hob is fitted with an adjustable "L" shape connector and a gasket to the gas
supply.
• The connector should be dismounted and the gasket must be replaced.
• The feeding connector of the gas to the hob is threaded 1/2" gas cylinder.
Connection to flexible steel tube
• The gas feed connector to the hob is threaded, 1/2" connector for round gas pipe.
Only use pipes and sealing gaskets that conform to the standards currently in force.
The maximum length of the flexible pipes must not exceed 2000 mm. Once the
connection has been made, ensure that the flexible metal tube does not touch any
moving parts and not be crushed.
Check the Seal
Once the hob was installed, make sure all the connections are properly sealed, use a
soapy water to test, never use flame.
Electrical Connection
The hob fitted with a tripolar electrical supply cord which are designed to be used
alternating current .According to the indications on the rating plate located under the
hob. The earthing wire can be identified by its yellow-green colour.
In the case of installation over a built-in electric oven, the electrical connections for the
hob and oven should be independent, not only for safe purpose, but also be convenient
to remove them in the future.
EN
43
Publicidad
