Preparation; Connections - Yamaha R-N602 Manual De Instrucciones

PREPARATION

CAUTION
• Do not connect this unit or other components to the main power until all connections between components are complete.
• All connections must be correct: L (left) to L, R (right) to R, "+" to "+" and "–" to "–". If the connections are faulty,
no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be
unnatural and lack bass. Refer to the owner's manual for each of your components.
• Do not let bare speaker wires touch each other or any metal part of this unit. This could damage this unit and/or the speakers.
• Make sure to use RCA cables, optical cables to connect audio components.
Turntable
Audio
GND
output
Audio Audio
output input
CD recorder, etc.
Only PCM signals can be input to the digital (OPTICAL/COAXIAL) jacks of this unit.
y
• The PHONO jacks are designed for connecting a turntable with an MM cartridge.
• Connect your turntable to the GND terminal to reduce noise in the signal. However, for some turntables, you may hear less noise
without the GND connection.
Note
In order to prevent the audio signal from looping when an audio recording device is connected, the audio signal is not output from the
LINE 2 (OUT) jacks when LINE 2 is selected. Similarly, the audio signal is not output from the LINE 3 (OUT) jacks when LINE 3 is
selected.

Connections

DVD player, etc.
O
PHONO
SIGNAL
GND
IN
1 1
OPTICAL
IN
2
2
1
OUT
COAXIAL
IN
2
3
CD
OUT
LINE
Audio
output
CD player Subwoofer
CD player, etc.
Audio output
C
(digital optical)
ANTENNA
FM AM
75Ω
SUBWOOFER
PRE OUT
Speakers A
Audio output
(digital coaxial)
NETWORK
SPEAKERS
A
B
Speakers B
11
En