Error Indications On The Front Display - Yamaha R-N602 Manual De Instrucciones

Message
Access denied
Access error
Check SP Wires
No content
Please wait
Unable to play
Version error
58
En

Error indications on the front display

Cause
Access to the PC is denied.
The unit cannot access the USB device.
The unit cannot access the iPod.
The connected iPod is not supported by
the unit.
There is a problem with the signal path
from the network to the unit.
The speaker cables short circuit.
There are no playable files in the selected
folder.
The unit is preparing for connecting to the
network.
The unit cannot play back the songs stored
on the iPod for some reason.
The unit cannot play back the songs stored
on the PC for some reason.
Firmware update is failed.
Remedy
Configure the sharing settings and select the unit as a device to
which music contents are shared (p. 31).
Turn off the unit and reconnect your USB device. If the problem
persists, try another USB device.
Turn off the iPod and turn it on again.
Use an iPod supported by the unit (p. 40).
Make sure your router and modem are turned on.
Check the connection between the unit and your router (or hub)
(p. 14).
Twist the bare wires of the cables firmly and connect to the unit
and speakers properly.
Select a folder that contains files supported by the unit.
Wait until the message disappears. If the message stays more than
3 minutes, turn off the unit and turn it on again.
Check the song data. If it cannot be played on the iPod itself, the
song data or storage area may be defective.
Check if the format of files you are trying to play is supported by
the unit. For information about the formats supported by the unit,
see "Playing back music stored on media servers (PCs/NAS)" (p.
31). If the unit supports the file format, but still cannot play back
any files, the network may be overloaded with heavy traffic.
Update the firmware again.