Mounting The Loop Handle - Stihl FS 55 Manual De Instrucciones

Mounting the Loop Handle

Mounting the Loop Handle with
Barrier Bar
2
1
N Fit the square nuts (1) in the barrier
bar (2); the holes must line up.
FS 55, FS 55 C, FS 55 R, FS 55 RC
4
5
6
N
Place the clamp (3) in the loop
1
handle (4) and position them both
against the drive tube (5).
N Place the clamp (6) against the
drive tube.
N Place the barrier bar (2) in position
as shown.
N Line up the holes.
N Insert the screws (7) and tighten
them down moderately against the
barrier bar.
N
Go to "Securing the Loop Handle".
2
3
7
Mounting the Loop Handle without
Barrier Bar
8
8
7
7
4
3
5
6
1
1
N
Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
N Place the clamp (6) against the
drive tube.
N Line up the holes.
N Fit washers (7) on the screws (8)
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
N Go to "Securing the Loop Handle".
English
19