Mounting The Loop Handle - Stihl FS 56 Serie Manual De Instrucciones

2
1
2
1
Push the throttle cable (1) into the
N
retainer (2).
FS 56, FS 56 R, FS 56 C, FS 56 RC

Mounting the Loop Handle

A factory-new machine comes with the
loop handle already mounted.
Using the Barrier Bar
A barrier bar may have to be mounted to
suit the cutting attachment you intend to
use – see "Approved Combinations of
Cutting Attachment, Deflector, Handle
and Harness".
The barrier bar comes standard with the
machine or is available as a special
accessory.
Mounting the Barrier Bar
1
1
2
2
5
5
3
3
Take out the screws (1) and remove
N
along with washers (2) and nuts (3).
Remove the loop handle (4) and
N
clamps (5).
3
Fit the square nuts (3) in the barrier
N
bar (6); the holes must line up.
English
4
3
19