Mounting The Loop Handle; Adjusting The Throttle Cable - Stihl FC 100 Manual De Instrucciones

English / USA

Mounting the Loop Handle

2
3
A
: Fit the loop handle (1) on the drive
tube 8" / 20 cm (A) forward of the
control handle (2).
: Position the clamp (3) against the
drive tube and slide it into the loop
handle.
16
1
: Fit square nut (4) in the loop handle,
insert the clamp screw (5) from the
other side and tighten down
securely.
Adjusting loop handle to most
comfortable position:
: Release clamp screw (5).
: Move the loop handle along the
drive tube as required - retighten the
clamp screw.

Adjusting the Throttle Cable

4
5
50 mm
( 2" )
:
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled
Use a suitable tool to push the slide
to the bottom of the slot
FC 100