Mounting The Cutting Attachment - Stihl FS 55 Manual De Instrucciones

Fitting the Skirt and Blade
4
4
1
5
These parts must be fitted to the
deflector (1) when you use a
mowing head.
N
Slide the lower guide slot of the skirt
(4) onto the deflector (1) – it must
snap into position.
N Push the blade (5) into the upper
guide slot on the skirt and line it up
with the first hole.
N Insert the screw and tighten it down
firmly.
FS 55, FS 55 C, FS 55 R, FS 55 RC
Mounting the Cutting
Attachment
Preparations
N Lay your brushcutter on its back so
that the cutting attachment
mounting face is facing up.
Mounting hardware for cutting
attachments
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
Mounting hardware is not packed
with machine
Only mowing heads can be mounted.
3
4
5
1
2
N
Pull the hose (1) (protector for
shipping) off the shaft (2).
N Go to "Mounting the mowing head".
If you want to mount a metal cutting
attachment in place of a mowing head,
you will need the following additional
parts: Nut (3), rider plate (4) and thrust
washer (5) (special accessories).
Mounting hardware is packed with
machine
Mowing heads and metal cutting
attachments may be mounted.
If the parts are packed with the
machine
N Pull the hose (1) (protector for
shipping) off the shaft (2).
The nut (3), rider plate (4) and thrust
wsher (5) are in the parts kit supplied
with the machine.
English
21