WAGNER F500 ELECTRONIC LED Manual Del Usuario página 6

EN
Attaching and Detaching the Cordset
The cordset (Fig. 2, 1) for the Heat Gun is delivered detached from the
gun (Fig. 2, 2). To attach, line up the cord with the socket on the handle
of the gun and press firmly together until you hear a click. The cord
set does not need to be removed. If required to detach, insert a small
flat head screwdriver (Fig. 2, 3) or, similar tool into the hole as shown.
Firmly push the screwdriver and tilt it upward (4) towards the handle
to release the cordset. Firmly pull the cordset away from the gun.
Attaching
Fig. 2
2
1
6
Touch Pad Control Panel
The heat gun gives you a wide temperature range to choose from,
depending upon the type of project. Temperature can be adjusted via
the Control Panel.
Temperature Guide LED display
Description Fig. 3
1) Power button: Turns the heat
Detaching
3) Mode indicator: Low air flow
5) Mode indicator: Cool down
3
7) Temperature selector:
4
gun ON and OFF or switches
to cool down mode
/ low temperature range (See
Fig. 4, a)
Decreases temperature (-)
Fig. 3
1
3
5
7
FURNO 500
2) Mode selector: Sets the
temperature range and air
flow speed you are using
4) Mode indicator: High air flow
/ high temperature range
(See Fig. 4, b)
6) Temperature indicator:
Shows the current heat
output setting (see Fig. 4)
8) Temperature selector:
Increases temperature (+)
2
4
6
8