Publicidad
Idiomas disponibles
Idiomas disponibles
APPLICATIONS
○ Cutting metal and stainless steel pipe.
○ Cutting various lumber.
○ Cutting mild steel, aluminum and copper plate.
○ Cutting synthetic resins, such as phenol resin and
vinyl chloride.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you (Fig. 5).
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery (Fig. 5).
Handle
Battery
Pull out
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on
the nameplate, the charger will burn out.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the pilot lamp will
blink in red. (At 1-second intervals)
ASSEMBLY AND OPERATION
Latch
Push
Insert
Fig. 5
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Firmly Insert the battery into the battery charger as
shown in Fig. 6.
Pilot lamp
3. Charging
When inserting a battery in the charger, the pilot lamp
will light up continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1- second intervals.) (See
Table 2)
(1) Lamp indication
The indications of the pilot lamp will be as shown
in Table 2, according to the condition of the battery
charger or the battery.
Indications of the pilot lamp (RED)
ON/OFF at 0.5 sec.
Before
intervals
charging
While
Lights continuously
charging
ON/OFF at 0.5 sec.
Charging
intervals
complete
Lights for 1 sec. at
Overheat
intervals of 0.5 sec. Battery overheated.
standby
ON/OFF at 0.1 sec.
Charging
intervals
impossible
*
Charging will commence when battery cools
English
Battery
Guide rail
Fig. 6
Table 2
Plugged into power
source
—
—
Unable to charge.*
Malfunction in
the battery or the
charger
11
Publicidad
