Publicidad
Idiomas disponibles
Idiomas disponibles
5. Plunge cutting (Fig. 25, and Fig. 26)
With this tool, you can perform plunge cutting on
plywood panels and thin board materials. You can
carry out plunge cutting quite easily with the saw
blade installed in reverse as illustrated in Fig. 26.
Use the saw blade that is as short and thick as
possible.
Be sure to use caution during the cutting operation
and observe the following procedures.
(1) Press the lower part (or the upper part) of the base
against the material. Pull the switch trigger while
keeping the tip of the saw blade apart from the
material.
(2) Raise the handle slowly and cut in with the saw blade
little by little.
(3) Hold the body fi rmly until the saw blade completely
cuts into the material.
NOTE
○ Using the collar or the base as support, gradually cut
in from the tip of the blade.
○ As the base is metal, using it for support may scratch
or damage the surface depending on the material
being cut. In this case, use the collar as support. If
you remove the base when window cutting, make
sure it is re-attached to the tool when you continue
operating the tool.
Collar
Fig. 25
CAUTION
● Avoid plunge cutting for metallic materials. This
can easily damage the blade.
● Never pull the Trigger switch while the tip of the
● Make absolutely sure that you cut slowly
6. How to use the LED light
● Do not expose directly your eye to the light by
● Wipe off any dirt or grime attached to the lens of
7. LED light warning signals
Fig. 26
saw blade is pressed against the material. If you
do so, the blade can easily be damaged when it
collides with the material.
while holding the body fi rmly. If you apply any
unreasonable force to the saw blade during
the cutting operation, the blade can easily be
damaged.
The LED light will light the area at the tip of the tool
when the switch is drawn.
The LED light will automatically power off 20 seconds
after the switch is released.
Trigger Switch
Fig. 27
CAUTION
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
activate during operation, the LED light will blink as
described in Table 6. When any of the safeguard
functions are triggered, immediately remove your
fi nger from the switch and follow the instructions
described under corrective action.
English
LED Light
17
Publicidad
